Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Gate Repair in Sebastian, FL | Miami Gardens Gate Repair
Ghost Controls gate repair in Sebastian usually comes down to one of two things: a salt-eaten connection or a solar system that gave up after a cloudy week on the lagoon. We’re Miami Gardens Gate Repair, an independent Ghost Controls service provider, and we work on these operators every week across Sebastian, Wabasso, and Micco. Most calls we run here aren’t motor failures. They’re corrosion, water intrusion, and battery issues that the salt air makes worse. Call us at (855) 382-0732 and we’ll diagnose it straight.
We’re not a Ghost Controls dealer and we’re not authorized by the manufacturer. That means we don’t push new units when a board swap fixes the problem. We tell you what actually failed, what it costs to repair, and when replacement honestly makes more sense.
Why Sebastian Residents Choose Us for Ghost Controls Service
Gates are all we do. Not garage doors, not fencing, not general handyman work. We’re Ghost Controls sales & service specialists who know the Stealth, ARES, and Titan lines from the control board out to the actuator arm. Noel Carballo, our owner and lead tech, studied electrical and mechanical systems at Miami Dade College’s North Campus before spending nearly two decades pulling apart operators, rewiring access systems, and figuring out why gates fail. He grew up around gates that stuck, groaned, or refused to open, and he still talks about limit switches at the dinner table. His daughter confirmed it.
Sebastian’s mix of canal-front homes, manufactured-housing communities, and older villas means we see a lot of Ghost Controls units that are structurally fine but electrically tired. Salt air gets into terminal blocks, solar leads wick moisture, and photo-eye connectors corrode after tropical-storm rain. We stock genuine Ghost Controls boards, batteries, and harnesses, plus marine-grade stainless fasteners and sealed connectors for the coastal hardware the factory kit leaves unprotected.
Styles & brands we work with





Common Ghost Controls Gate Repair Problems We Solve in Sebastian
- Slow or sticking actuator arms on canal-front gates. Salt-spray oxidation builds up on the arm, limit switches, and terminal blocks. On lagoon-side properties we see this within two or three seasons. The gate still moves, but it labors, and that strain burns out the board eventually.
- Dead solar systems after cloudy stretches. The motor’s fine. The problem is the charge controller or battery cables, which wick moisture off the lagoon air and corrode green. We replace the harness with sealed marine-grade connectors and raise the enclosure off the splash line.
- Photo-eye and accessory-wire faults after tropical-storm rain. Water gets pushed into low-voltage connectors at the control box and kills the safety reverse before the board fails. The gate will usually refuse to close, not open, when this happens.
- Control-box water intrusion on dock and boat-lift gates. Low-mounted enclosures near tidal splash and blowing rain take on water. The board shorts, or surge damage cooks it. We reseal, relocate, or replace depending on what the housing looks like inside.
- Binding swing arms in summer. Sebastian’s heat and humidity cause metal posts and hinge plates to expand and shift. A gate that runs fine all winter starts binding near the end of travel in July. Usually it’s a hinge and post alignment fix, not a motor problem.
Ghost Controls Service in Sebastian: What Local Conditions Mean for Your Equipment
Here’s something you won’t read on a generic Ghost Controls page. Sebastian’s canal-front homes on the lagoon side commonly run two Ghost Controls systems: a driveway gate and a separate boat-lift or dock gate. The dock-side unit corrodes two to three times faster because it lives in constant tidal moisture and salt fog that the street-facing gate never sees. We’ve replaced dock-gate boards that looked like they’d been dipped in seawater while the driveway operator on the same property was still in decent shape. Along the US-1 corridor toward Wabasso and Micco, manufactured-home communities with lagoon access have the same pattern. If you own a canal-front property in the 32958 ZIP and your Ghost Controls dock gate is acting up, the fix is almost always in the wiring and connections, not the motor.
Out toward Ghost Controls service in Micco, one manufactured-home community had a lagoon-side dock gate running a Ghost Controls Stealth swing kit that quit after a stretch of squally weather. Our tech found the solar charge controller fried and the battery leads green with corrosion. We replaced the controller and harness with sealed connectors, raised the enclosure, and re-paired the resident remotes the same afternoon. The dock stayed usable through the rest of hurricane season.
Ghost Controls Models & Products We Service in Sebastian
We service the full Ghost Controls lineup across Sebastian and the surrounding Treasure Coast communities. That includes Stealth single swing gate kits, ARES dual swing operators, Titan series slide gate operators, and the solar accessory kits with their panels, charge controllers, and battery harnesses. We also handle battery backup systems, hinge and post repair, and motor repair on every Ghost Controls configuration we see locally.
When parts are needed, we use genuine Ghost Controls boards, arms, batteries, and harnesses where the unit is still supported. On coastal hardware, we upgrade what the factory kit doesn’t protect: marine-grade stainless fasteners, sealed connectors, dielectric grease on terminals. If a control board is the only fault, we replace the board and keep your operator. If the motor housing, gearing, and battery tray are all salt-eaten, we’ll tell you straight that a new operator costs less over the long run.
See the difference
Before
After
Before
After
Before
AfterGhost Controls Service Pricing in Sebastian
Ghost Controls repair in Sebastian typically runs from $150 to $550 depending on what failed. A photo-eye alignment or hinge adjustment lands on the low end. A control board replacement or solar harness rebuild sits higher, especially on dock-side units that need enclosure relocation and sealed connector work. Full operator replacement, when it’s the honest call, is a separate quote we walk you through before any work starts.
Our estimate is free and it’s specific. We tell you what failed, what we’re replacing it with, and what it costs before we touch a single screw. Call (855) 382-0732 for an exact quote on your Ghost Controls system in Sebastian, Wabasso, or Micco.
Serving Sebastian, FL — Our Local Coverage Area
We’re based in the Sebastian area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Ghost Controls Gate Repair in Sebastian
Probably not. The motor is usually the last thing to fail. After a cloudy stretch, the solar charge controller or battery cables are the likely culprits, especially on lagoon-side properties where salt moisture accelerates corrosion on the leads. We test the motor before recommending any repair, and in most cases the fix is a new controller and sealed harness, not a motor replacement. Call (855) 382-0732 and we’ll diagnose it on site.
Yes, and it usually saves you money. The dock-side unit corrodes far faster than the street-facing gate because it sits in constant tidal moisture and salt fog. Servicing both at once lets us inspect connections, check solar harnesses, and catch small corrosion before it kills a board. One trip, both gates looked at, one estimate. Call (855) 382-0732 to schedule a combined service visit in Sebastian.
Yes. After a board replacement, we re-pair all existing remotes, keypads, and any accessory modules so everything works the way it did before the failure. We handle the programming on site, same visit. If a remote was already failing before the board swap, we’ll tell you and price a replacement separately.
Sebastian’s summer heat and humidity make metal posts and hinge plates expand. The geometry shifts just enough that the arm binds near the end of travel. It’s almost never a motor problem. We inspect the hinges, post alignment, and actuator mounting, then adjust or replace the worn hardware so the gate runs clean through its full travel. Call (855) 382-0732 for a free estimate on a hinge and post repair.
You should have the control box seals, solar harness connections, and battery terminals checked before the first big storm. Water intrusion and surge damage are the two things that knock out Ghost Controls operators on Sebastian’s lagoon side. We reseal enclosures, relocate low-mounted boxes, and replace corroded connectors so the system survives a squall. Schedule a pre-season inspection at (855) 382-0732.
Service Areas Near Sebastian
We service Ghost Controls operators throughout Sebastian and the surrounding communities, including Wabasso, Micco, Roseland, and Barefoot Bay. For customers further south, we offer Ghost Controls service in Charlotte Park and Ghost Controls service in Punta Gorda. If you’re in the 32958, 32976, or 32978 ZIP codes, we’re already covering your neighborhood. See our full Sebastian service area page for details.
Book Your Ghost Controls Service in Sebastian Today
If your Ghost Controls gate is sluggish, dead, or stuck, call us at (855) 382-0732. We’ll get a tech out, diagnose the real problem, and give you a price before any work starts. Gates are all we do, and we know exactly how salt air and lagoon moisture treat a Ghost Controls operator in Sebastian.
Written by Noel Carballo, Owner at Miami Gardens Gate Repair, serving Sebastian and the Treasure Coast with independent Ghost Controls service and repair.