Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across Hobe Sound
Electric gate repair in Hobe Sound usually comes down to one of three failures: a salt-corroded connection at the gate column, a control board that took a power surge, or a post that shifted in rain-soaked ground. Most calls we run in 33455 and 33475 are fixed the same visit. If your gate is stuck, beeping, or intermittently refusing to open, call (855) 382-0732 and we’ll get a technician out to your property.
We know the long private drives off SE Bridge Road, the gated entries along the Intracoastal corridor, and the older ranch homes tucked back from Federal Highway. Hobe Sound is not a tract-home market. It’s custom swing gates on acre-plus lots, solar operators on barrier-island estates, and slide gates that run sixty feet on buried conduit. That’s the work we do every day.
Why Miami Gardens Gate Repair Is Hobe Sound’s Preferred Electric Gate Repair Company
We work on gates exclusively. Not garage doors, not fencing, not general contracting. Every diagnostic call, every tool on the truck, and every part we stock is oriented around one trade. That focus matters in Hobe Sound because the gate systems here are not off-the-shelf hardware. They are LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule operators bolted to custom ornamental steel and tied into access control panels that run keypads, loop detectors, and photo-eyes.
Property managers along the Jupiter Island-adjacent corridor call us because we can identify a failing operator by its sound and behavior, not by reading a manual in the driveway. Homeowners call us because we don’t push a replacement when a $40 corroded wire is the actual fault. That brand-agnostic troubleshooting is the whole point of being a gate specialist. We know competing manufacturers side by side, so the fix we recommend is the fix the system actually needs.
Led by Noel Carballo, our team trains on control board diagnostics, motor failure patterns, and access-system integration across all nine major brands. When a Hobe Sound gate fails, you get a tech who recognizes the unit on sight and starts working, not one who starts guessing.
Styles & brands we work with





Electric Gate Motor in Hobe Sound
An Electric Gate Motor in Hobe Sound is the muscle behind swing and slide operators on long private drives, and it fails differently here than it does inland. Salt-laden air off the Atlantic works its way into motor housings and terminal connections. High humidity during the wet season accelerates corrosion on contacts. Hurricane-season wind load on a solid infill gate pushes the motor well past its duty rating, and that strain shows up as burned capacitors, tripped limit switches, and overheated windings.
A typical electric gate motor repair in Hobe Sound runs $275 to $650 depending on whether we’re replacing a capacitor and cleaning terminals, or swapping a burned armature and retuning the limit settings. Full motor and operator replacement on a heavy slide gate can run $1,400 to $3,200 with the operator, mounting, and integration into the existing access system. We quote the price before any work starts, so you know exactly what the job costs before we turn a wrench.
Motor Diagnostics on Coastal Drives
On Intracoastal-side estates, we see motors that still run but can’t move the gate. The operator strains because a post shifted in saturated ground, or a carrier wheel is dragging through sand that blew in during the last storm. We test the motor under load, check its amp draw against spec, and separate a mechanical bind from an electrical failure before recommending any repair.
Post-Storm Motor Service
After a hurricane or tropical storm, power surges and brownouts knock out motor control boards and limit switches on both AC and solar gate openers. We carry replacement boards for all nine brands we service and can usually get a storm-damaged motor running the same day we diagnose it.
Gate Access Control in Hobe Sound
Gate Access Control in Hobe Sound covers everything that tells the gate who to let in: keypads at the column, remote controls in the car, loop detectors in the paver driveway, and the receiver cards inside the operator. On coastal properties this equipment takes a beating from salt spray and blowing sand, and the failure is usually intermittent. The keypad works when it’s dry and dies when humidity climbs. The remote works in the driveway but not from the street.
Access control repair in Hobe Sound typically runs $140 to $400 for keypad replacement, receiver card service, or photo-eye alignment. Full system upgrades with new keypads, remotes, and a modern receiver kit run $600 to $1,400 depending on how many entry points and user codes the property needs. Every quote is written and agreed before work begins.
Keypads and Corroded Wiring at the Gate Column
We replace keypad entry runs more often in Hobe Sound than nearly anywhere else we work. The low-voltage wiring inside the gate column corrodes from salt air and moisture, and the keypad stops sending signal even when the keypad itself looks fine. We cut back the corroded length, run fresh conductors, and seal the connections properly so the repair holds through multiple storm seasons.
Loop Detectors and Photo-Eye Systems
Long driveways off SE Bridge Road rely on loop detectors buried in the pavers to open the gate automatically when a car approaches. Salt intrusion and cracked conduit compromise those loops over time. We troubleshoot the detector, the loop wire, and the relay logic together, because the gate opening late is just as inconvenient as the gate not opening at all.
Trusted Brands We Service in Hobe Sound
We’re factory-familiar with LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. That covers virtually every operator a Hobe Sound homeowner or property manager could own. Because we stock parts for all nine brands and understand each manufacturer’s control logic, we can often rebuild a failing operator rather than replace it. When a replacement is the honest call, we’ll tell you that too – and we’ll get you the right unit instead of selling you whatever is on the truck.
See the difference
Before
After
Before
After
Before
AfterCommon Electric Gate Repair Problems We See in Hobe Sound Homes
- Salt-fouled photo-eye lenses. The safety photocells at the gate column get coated in salt film from onshore spray, and the gate reverses or refuses to close because it thinks something is in the path. We clean and reseal the lenses, then verify the UL 325 entrapment protection before we leave.
- Corroded low-voltage wiring at the column. Keypads, photo-eyes, and receiver antennas all run wiring through the gate post. In Hobe Sound’s salt air, those connections corrode and fail long before the operator does. This is the most common “gate won’t open” fix we make.
- Post footings shifting in saturated ground. Long slide and swing gates hang from posts that sit in soil that gets drenched during the rainy season. When a post shifts, the gate drifts off the rack and pinion, drags, and trips the operator limits. We correct the sag and re-anchor the post.
- Storm-surge damage to control boards. Power surges and brownouts during hurricane season fry control boards and limit switches, especially on solar gate openers with older charge controllers. We replace the board, test the battery bank, and set the limits to factory spec.
Pricing for Electric Gate Repair in Hobe Sound, FL
Electric gate repair in Hobe Sound runs $140 to $650 for most diagnostic and component-level repairs. Photo-eye cleaning and resealing starts around $140. Keypad entry run replacement runs $180 to $400. Motor repair runs $275 to $650. Control board replacement runs $300 to $800 with the part. Full operator replacement on a heavy slide or swing gate runs $1,400 to $3,200. The quote is written and agreed before any work starts, so there’s no invoice surprise. Call (855) 382-0732 for a free estimate on your specific gate.
We Also Serve Cities Near Hobe Sound
Our Electric Gate Repair team runs daily routes through Port Salerno, Tequesta, Stuart, and Jupiter. If your property sits just outside Hobe Sound in one of those towns, the same technicians and the same parts inventory cover you. You can think of this page as your local hub for Electric Gate Repair in Hobe Sound and the surrounding coastal communities.
Serving Hobe Sound, FL — Our Local Coverage Area
We’re based in the Hobe Sound area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Hobe Sound
The gate operator probably lost its low-voltage signal, not its motor. In Hobe Sound, storm-driven salt spray coats the safety photo-eye lenses and wind-driven rain gets into keypad wiring at the gate column. The motor runs because it still has power, but the access system is telling it to stay put. We clean the photo-eyes, reseal them, test the keypad wiring, and verify entrapment protection. Call (855) 382-0732 and we’ll walk you through a quick check before we even dispatch.
Every automatic gate has a manual release mechanism, usually a lever or a keyed lock on the operator itself. For swing gates, you pull the release handle and the gate swings free by hand. For slide gates, the release disengages the rack and pinion so you can slide the gate manually. If the gate is solid infill and heavy, get a second person. After you restore power, the operator should re-engage on its next automatic open-close cycle. If it doesn’t, the limit switch or release mechanism may need service.
Yes. UL 325 requires automatic gates to have working entrapment protection – photo-eyes, edge sensors, or both – that reverses the gate if something is in the path. In Hobe Sound, salt and sand accelerate photo-eye failure, so the system can lose entrapment protection without the homeowner ever noticing until the gate reverses for no reason or fails a safety test. We test entrapment protection on every repair visit and flag any gate that is running without it.
Long driveway gates on acre-plus Hobe Sound lots weigh more and get more wind load than short residential gates. The hinge post or slide rail takes that stress over years, and the gate slowly drifts out of alignment until it drags on the pavers or loses its rack and pinion mesh. In saturated ground after heavy rain, the post itself can shift. We correct the sag, re-anchor the post if needed, and reset the operator limits so the motor isn’t fighting the gate every cycle.
Solar gate openers work well in Hobe Sound’s open southern exposure, but the charge controller and battery connections corrode in salt air just like any other low-voltage component. The control boards also take surge damage during hurricane season when lightning and grid flicker hit. We service solar openers from Linear, Ghost Controls, Mighty Mule, and the other brands we carry, and we test the battery bank, charge controller, and panel output together rather than assuming the motor is the problem.
If your electric gate is stuck, noisy, intermittent, or just not responding the way it used to, call (855) 382-0732. We’ll send a technician who knows your gate brand and knows Hobe Sound’s coastal conditions. Free estimates, quoted and agreed before any work starts.
Written by Noel Carballo, Owner at Miami Gardens Gate Repair, serving Hobe Sound’s electric gate systems across 33455 and 33475.